2027 Peterbilt 567
$259,500.00 (954) 584-3200
Key Features
- ✔ 510 HP PACCAR MX-13 Engine, 1,850 lb-ft Torque
- ✔ Allison 4500 RDS-P 6-Speed Automatic
- ✔ 16.5' Air-Flo Hardox AR 450 Steel Dump Body
- ✔ 79,500 lb GVWR with 13,500 lb Self-Steer Pusher
- ✔ Hendrickson HAULMAAX 46,000 lb Rear Suspension
- ✔ Bendix ESP Stability Control with Air Disc Front Brakes
- ✔ 2-Year/250,000-Mile PACCAR MX Engine Warranty
- Stock Number:
- VD 822590
- Model:
- 567
- Location:
- The Peterbilt Store - Fort Lauderdale
Overview
Overview
This new 2027 Peterbilt 567 conventional day cab is set up as a tri-axle construction dump truck for on/off-highway service hauling construction materials. It carries a 16.5' Air-Flo heavy-duty steel dump body built from Hardox AR 450. It is rated at a 79,500 lb GVWR and 80,000 lb GCW, with a 20,000 lb front axle, a 46,000 lb tandem rear and a 13,500 lb self-steering pusher axle. The powertrain is a 510 HP PACCAR MX-13 paired with an Allison 4500 Rugged Duty Series automatic.
Engine & Drivetrain
The PACCAR MX-13 Performance engine is rated at 510 HP at 1,600 RPM, governed at 2,200 RPM, with 1,850 lb-ft of torque at 1,000 RPM. It is a 2024-series emissions engine with a model year 2026 engine designation, and it is CARB emission compliant and CARB idling compliant. The engine has a compression brake with controls on the right-hand column, an enabled engine idle shutdown timer, engine monitoring protection with derate, and a powertrain optimized for frequent start/stop service. Typical operating speed is set at 62 MPH. A cab-station PTO mode control and a 12-pin remote PTO/throttle provision in the engine bay come equipped. Supporting equipment includes a PACCAR 160-amp brushed alternator, PACCAR premium starter, three PACCAR premium 12V dual-purpose batteries (2,190 CCA), a 110–120V immersion block heater, and a WABCO 25.9 CFM air compressor. It also has a 2-speed fan clutch, high-efficiency cooling system, PACCAR MX fuel cooler, and on-engine PACCAR fuel/water separator with extended service interval. Air intake runs through dual self-cleaning under-hood pre-cleaners and a firewall-mounted air cleaner. Exhaust is a single right-hand system with the DPF/SCR in a single module under the right side of the cab, exiting through a 7" chrome-plated steel standpipe, 24" tall, with a curved tip. Power goes to an Allison 4500 RDS-P Gen 6 Rugged Duty Series transmission in a 6-speed configuration with a TC-571 torque converter and a dash-mounted push-button shifter. It runs Allison primary shift schedule 1, with neutral at stop and auto neutral when the parking brake is set. The driveline is a Spicer SPL170 HD-XL main driveline with one midship bearing and an SPL170 XL interaxle driveline. A dash-mounted, single-acting electric-over-hydraulic PTO control works the dump system. Rear axle ratio is 4.30.
Chassis & Axles
The 567 rides on a 235" wheelbase with a 90.1" bumper-to-back-of-cab dimension, 144.9" cab-to-axle and 204.9" cab-to-end-of-frame. The frame uses 10-3/4" steel rails at 3/8" thickness with a full steel inner liner, aluminum frame crossmembers, heavy-duty iron front spring brackets, and a square end of frame with a steel crossmember. The front axle is a Meritor MFS20 rated at 20,000 lbs with a 3.5" drop and a wide track. Steering is a Sheppard HD94 dual-gear power steering system with a frame-mounted reservoir and cooler. The rear tandem is a Meritor RT46-160 rated at 46,000 lbs, with tandem differential locks (speed interlock and a separate dash control for full lock), a drive axle lube pump, and synthetic lubricant in all axles. A Hendrickson EXS13 self-steering pusher axle rated at 13,500 lbs sits 54" ahead of the forward drive axle centerline. It includes its own air tank, a lift axle regulator with dash switch and gauge, and stows higher when lifted to maximize ground clearance. Engineering ratings are 20,000 lbs front GAWR, 13,500 lbs first intermediate, 23,000 lbs second intermediate and 23,000 lbs rear GAWR, for a 79,500 lb GVWR and 80,000 lb GCW. Maximum grade rating is 6 percent. Braking uses air disc brakes up front and Bendix air cam 16.5x7 rear drum brakes with X30 drums, reinforced rear camshafts, gusseted cam brackets, and dust shields on the drive axles. The truck adds an SBM valve, pneumatic and upsized parking brakes, the Bendix ESP Electronic Stability Program with ATC (with dash deactivation switch), and 6S6M ABS. The air system has a heated Bendix AD-HF EP air dryer with coalescing filter and extended purge, aluminum air tanks polished outside the frame rails, pull cords on all tanks, nylon chassis hose, and a dash-mounted self-returning brake hand valve. Body connections are located 5' back of cab, with AE connections in the end-of-frame crossmember. Fuel is carried in a polished 26" aluminum 110-gallon tank under the left side of the cab, with a polished non-slip step and polished straps. A 24-gallon DEF tank with a polished stainless cover mounts left side back of cab. An aluminum space-saver battery box with side access mounts right side back of cab and is polished. A polished, set-forward, deep tapered aluminum bumper has a toe step cutout.
Suspension
Rear suspension is a Hendrickson HMX EX 460 HAULMAAX rated at 46,000 lbs with a 54" axle spread and a 70K creep rating. Up front, 20,000 lb taper leaf springs work with Tenneco steer axle shocks, greasable front spring pins, and 80 mm front spring spacer blocks. Cab air suspension is also fitted.
Cab & Interior
The day cab is a 121" BBC aluminum cab with a Metton hood, stainless steel crown and grille, and hood tilt assist, plus a thermal insulation package and 2.25" fender lips. Inside is a Prestige interior in Sterling Gray. The driver gets a Peterbilt LX premium air-ride high-back seat in black fabric/vinyl with left and right armrests. The passenger seat is a Peterbilt ST non-adjustable high-back vinyl seat with a left armrest, a toolbox underneath, and tow hook holders. A premium leather-wrapped multi-function steering wheel with audio and cruise controls sits on a tilt/telescoping column. The main instrument panel is a 15" digital cluster. It displays front and rear drive axle oil temperatures, engine and transmission oil temperatures, and air filter restriction with increased full indication. It also shows brake application and trailer reservoir air pressure, engine and PTO hourmeters, turbo boost, engine percent torque, and pusher axle pressure. Two additional dash switches come pre-wired. Technology includes a 7" infotainment display with Apple CarPlay, a four-speaker midlevel speaker package, radio mute in reverse, a low-mount left cowl CB antenna, global telematics hardware, and a 5-year SmartLINQ remote diagnostics/over-the-air subscription for the PACCAR MX engine. Comfort and visibility features include a combination fresh-air heater/air conditioner, power door locks and windows, dark window tint, a one-piece curved windshield, a fixed one-piece rear window, intermittent electric wipers, and a stainless steel outside sunvisor. Mirrors are motorized, heated Peterbilt aero mirrors with integrated convex lenses in bright housings, bright round hood mirrors, and a look-down mirror over the passenger door. Also included are a textured NFPA-compliant exterior grab handle, an under-cab air horn, a removable bug screen behind the grille, auto-reset circuit protection, a fire extinguisher, a triangle reflector kit, and an 87–112 dB variable backup alarm. Lighting includes projector headlights with fender-mounted turn signals, daytime running lights, five LED aero marker lights, bracket-mounted LED stop/turn/tail/backup lights, and two flush-mounted load lights. The cab is finished in two-stage Axalta White on the cab, hood, hood top, roof, and fenders, with a black frame.
Body & Equipment
The Air-Flo heavy-duty steel dump body is 16.5' long and 99" wide overall, with 54" sides and a 60" tailgate. The sides are smooth 3/16" Hardox AR 450 with no gussets, a 4" top rail, and a dirt-shedding bottom rail. Painted 14'–17' side boards are fitted. The floor is 1/4" Hardox AR 450 over 3/16" formed high-strength steel longsills, with no crossmembers. The tailgate is a 1/4" Hardox AR 450, 60" two-panel high-lift design with an air-operated latch, and a 10" bolt-on formed spreader apron is fitted. Lifting is handled by a single-acting front trunnion telescopic hoist with a rear hinge, fed by a slim front-mount steel doghouse reservoir. A hot shift PTO with dump pump runs off the Allison automatic, controlled through the factory/OEM PTO switch. Body controls are air-operated on an aluminum tower, and two body props are included. A 24" cabshield, 70" wide, carries forward and side lights. A front left-side ladder has three inside steps, a lower step, a grab handle, and a weld-on shovel holder. Other equipment includes a low-mount arm tarp system and a 50-ton pintle hook rigid tow package with plate, trailer plug, and D-rings. Lighting includes six strobes (two on the rear corner posts, two on the front of the cabshield, two on the cabshield sides), LED stop/turn/tail, marker and clearance lights on a factory rear light mount, and a backup alarm. Rubber rear mud flaps and front aluminum splash guards are fitted. The body is grit-blast prepped, epoxy primed, and painted black.
Tires & Wheels
The steer axle runs 20-ply 315/80R22.5 HSC3 tires with TPMS sensors on Alcoa 89U637 22.5x9.00 high-polish aluminum wheels. The tandem drive carries eight 16-ply 11R22.5 HSC3 tires with TPMS sensors on Alcoa 885657 22.5x8.25 high-polish severe-service aluminum wheels. The self-steering pusher axle runs two 16-ply 11R24.5 HSR3 tires on Alcoa 98U637 24.5x8.25 high-polish aluminum wheels. Every position has a mirror-polished outer surface with Dura-Bright finish. Wheel guards are fitted between brake drum and wheel and between wheels on the tandem, and between brake drum and wheel on the pusher axle. A tire pressure monitoring system is standard.
Warranty & Protection
This new unit has PACCAR MX standard engine coverage of 2 years/250,000 miles (400,000 km)/6,250 hours. It also has Peterbilt Class 8 standard coverage of 1 year/100,000 miles (160,000 km) and base emissions coverage of 5 years/100,000 miles.
Specifications

Estimate Your Monthly Payment
Use our online tool to get an estimated monthly payment and see how different financing options can impact your bottom line.
Our Experienced Finance Team is Here to Help
We work with a network of lenders to secure the most competitive rates available.
Fast and Easy Approvals:
Get the green light quickly so you can focus on running your business.
Expert Guidance:
Our knowledgeable finance professionals will guide you through every step of the process.
